THE INFLUENCE OF SHUNGITE NANOPOWDER MODIFICATOR ON WATER THICKNESS SWELLING AND WATER ABSORPTION OF THREE PLY PARTICLE BOARD

Authors

  • Pitukhin Aleksandr Vasilyevich Faculty of Forest Engineering, Petrozavodsk State University, 33, Lenin Str., 185910, Petrozavodsk, Republic of Karelia, Russi Author
  • Kolesnikov Gennady Nikolaevich Faculty of Civil Engineering, Petrozavodsk State University, 33, Lenin Str., 185910, Petrozavodsk, Republic of Karelia, Russia Author
  • Panov Nikolai Gennadievich Faculty of Forest Engineering, Petrozavodsk State University, 33, Lenin Str., 185910, Petrozavodsk, Republic of Karelia, Russi Author
  • Vasilyev Sergey Borisovich Faculty of Forest Engineering, Petrozavodsk State University, 33, Lenin Str., 185910, Petrozavodsk, Republic of Karelia, Russi Author

Keywords:

shungite nanopowder, particle board, water thickness swelling, water absorption

Abstract

As the result of experimental investigation it was found out that the 10 % of shungite nanopowder when mixed in the glue decreases water thickness swelling of three-ply particle board up to 14.2 % and water absorption by 10.6-20.1 %. The influence of the 10 % shungite nanopowder additive on physical-mechanical indicators of particle boards depends on the resin type used for making the glue. Wooden particles of aspen and coniferous species as well as glue solution based on two types of carbamide formaldehyde resin were used for boards manufacturing. The shungite nanopowder contained particles 50...100 nm by the size and specific surface 120 m2/g. In the course of the experiment three-ply particle boards with the thickness 15.6 mm.

Downloads

Published

20-01-2026

Issue

Vol. 26 No. 1 (2018): Solid State Science and Technology

Section

Articles

License

Copyright (c) 2018 Solid State Science and Technology

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.